Kyocera Mita TK3102, TK3112, TK3122, TK3132

THESE ARE TONER CARTRIDGES THAT DO NOT HAVE AN INTEGRATED DRUM UNIT. THE DRUM IS A SEPARATE UNIT FROM THE TONER CARTRIDGE.

These cartridges are all physically the same but have different chips for the different specific printer models. Make sure you have the correct cartridge for your specific printer model.

These are compatible cartridges so there will be some differences from the OEM; these differences will NOT affect the function.

There is a waste toner box included with our compatible cartridge which will need to be replaced at the same time as the toner cartridge.

Not Recognizing

Verify you have the correct cartridge for your specific printer model.

There is a smart chip located on the end of the toner cartridge. Check to make sure this chip isn’t missing or damaged. Finger print oil can cause false readings so you may want to clean the contacts with a lint-free cloth and attempt to re-install the toner cartridge.

To remove and replace the toner cartridges in a FS-2100dn printer do the following;

– Open the top cover.

– Turn the lock lever to the unlock position.

– Carefully remove the toner cartridge from the printer.

– Set the new toner cartridge in the printer straight down.

– While pushing down on the top of the toner cartridge, turn the lock lever to the lock position.

– Close the top cover.

The waste toner box will need to replaced at the same time as the cartridge. To replace the waste toner box do the following;

– Open the left cover.

– While holding the waste toner box, press the lock lever and then gently remove the waste toner box.

– Close the cap to the old waste toner box after removing the box from the printer.

– Open the cap of the new waste toner box.

– Insert the new waste toner box. When the box is set correctly, it will snap into place.

– Make sure that the waste toner box is correctly inserted and close the left cover.

Kyocera Mita requires that the printer must be cleaned when a toner cartridge and waste toner bottle are replaced. Failure to clean the printer may cause print quality issues. To clean the printer do the following;

– Open the top cover and front cover.

– Pull the developer unit together with the toner cartridge.

– Use a lint free cloth to clean dust and dirt away from the register roller (metal).

– Insert the developer unit together with the toner cartridge, back into the printer.

– Close the front cover and top cover.

– Open the left cover. Use a lint free cloth to clean dust and dirt away from the vents.

– Close the left cover.

Print Quality Issues

Make sure the cleaning outlined above was completed.

There is a clear pull tape seal that must be removed from the toner shutter.

Shake the toner cartridge 5 or 6 times to distribute the toner evenly inside the cartridge. Do not touch the chip or the part of the cartridge outlined in the picture below.