THIS IS A TONER THAT HAS THE OPC DRUM BUILT INTO THE CARTRIDGE ITSELF AND IS REPLACED AS ONE WHOLE UNIT.  THERE IS NO SEPARATE DRUM UNIT.

 

Not Recognizing

 

Verify the customer has the correct cartridge for their specific printer.

 

There is a smart chip located on the front of the cartridge.  Check the chip for damage or debris.  You can use a Q-tip to reach and clean the four gold contacts.

 

Make sure the cartridge is installed correctly and is fully inserted into the printer.

 

To remove and install this cartridge into a Ricoh AC205 printer do the following;

–          Open the front door.

 

–          Lightly pushing the cartridge down, pull it out.

 

–          Holding the toner cartridge by the handle.  Slowly insert the cartridge into the opening in the printer.  Tabs on the sides of the cartridge and corresponding grooves within the printer will guide the cartridge into the correct position until it locks into place completely.

 

–          Close the front door.

 

Print Quality Issues

 

There is an orange plastic protective cover on the front of the cartridge which must be removed prior to installation.

 

Holding both sides of the cartridge, thoroughly rock it from side to side to evenly distribute the toner.

 

The OPC drum is located on the bottom of the cartridge.  Do NOT touch the drum.  Visually inspect the OPC drum for damage or debris.  A soft, clean, dry, lint-free cloth can be used to gently clean the OPC drum.  Care must be taken while handling the cartridge as there is no plastic shutter protecting the OPC drum on the bottom so it can easily be nicked or scratched when set on surfaces or handled.

 

If the toner is smearing off the paper or isn’t adhering properly, make sure the paper settings on the printer match the paper type being used.  Thicker paper, such as labels or bonded paper, require a different paper setting to allow more heating while printing to ensure the toner melts properly to the paper.  Trying to print on thicker paper while under that standard paper setting will cause the toner not to get enough heat to melt properly.

 

If there are streaks or spots on the prints, there is a cleaning function on the printer to help resolve this.  To run this cleaning do the following;

–          Make sure there is paper loaded in the paper tray.

–          Press MENU on the control panel until “Maintenance” appears on the top line of the display.

–          The first available menu item, “Clean Drum,” displays on the bottom line.

–          Press ENTER.  The printer prints out a cleaning page.  Toner particles on the drum surface are affixed to the paper.

 

Leaking

 

This toner does not have any pull seal tabs and as a result a little toner dust on the cartridge is normal.  Vibrations during shipping may cause the roller to rotate a little and allow a little toner powder to leak.  This is normal.  You can clean excess toner dust off the cartridge by gently wiping the cartridge with a clean, dry, lint-free cloth or gently blowing on it.  Be careful with compressed air as this may blow too powerfully and blow toner powder out of the cartridge.  Do NOT use moisture of any kind.

 

Not Fitting

 

Verify they have the correct cartridge for their specific printer model.  Check inside the printer for any obstructions which may be causing the cartridge not to fit.  Check the cartridge itself for physical damage.