THIS TONER CARTRIDGE DOES NOT HAVE INTEGRATED DRUM UNIT.  THE DRUM IS A SEPARATE UNIT FROM THE TONER CARTRIDGE.

 

This toner cartridge comes with a new waste toner box that must be replaced at the same time as the toner cartridge. It also comes with an extra waste toner box in case the box needs to be replaced before the next toner change.

 

Not Recognizing

 

Verify you have the correct cartridge for your specific model printer.

 

This cartridge uses a RF or radio frequency sensor chip that’s located on the bottom of the cartridge. This chip does not make physical contact with the printer but rather sits in a specific position to be picked up by the printer’s sensor. Make sure that the cartridge is properly inserted and locks into place to ensure the chip is in the correct position. If the problem persists it is most likely an issue with the chip on the cartridge.

 

To remove and install both the toner cartridge and the waste toner box in the Kyocera Mita FS-6025MFP printer do the following;

–          Push the release button and pull open the front cover.

 

–          Locate the toner release lock lever.

 

–          Pull the lever out 90 degrees to release the toner cartridge.

 

–          Pull the toner cartridge out from the printer.

 

–          Insert the new toner cartridge into the printer being sure you have the cartridge faced in the correct orientation.

 

–          Push the toner cartridge until it clicks into place.

 

–          Grasp the the waste toner bottle located to the right of the toner cartridge and remove it from the printer.

 

–          Open the cap to the new waste toner bottle.

 

–          Insert the waste toner bottle into the printer, making sure it’s facing in the correct orientation.

 

–          Push the waste toner bottle until it clicks into place.

 

–          Close the front printer cover.

 

Print Quality Issues

 

If the pages are coming out light, try removing the toner cartridge and tapping on the top of the cartridge.  Then, shake the toner cartridge horizontally to redistribute the toner evenly.

 

If the toner is smearing or coming off the paper, try switching to a thicker paper media setting.  The paper media selection can be changed under the Paper Selection menu option on the touchscreen of the printer.

 

Streaking, lines, ghost images, and repeating image defects are drum related issues.  The drum unit is separate from the toner cartridge.

 

Not Fitting

 

Verify you have the correct cartridge for your specific printer model.  Check to make sure the cartridge is being installed in the correct orientation.  Check the inside of the printer for any obstructions that may be causing the cartridge not to fit properly.  Check the cartridge itself for physical damage.