This is sold as a 2 pack so you get 2 toner bottles and 2 waste toner bags.

THIS TONER CARTRIDGE DOES NOT HAVE THE OPC DRUM INTEGRATED.  THE DRUM UNIT IS A SEPARATE.

This is not a toner cartridge that installs into the printer.  Instead it simply re-fills the toner box inside the printer with toner powder and then is discarded.

 

Not Recognizing

 

Verify you have the correct toner bottle for your specific printer model.

 

The toner is electrically sensed inside the toner hopper of the printer.  The refill toner bottle has no electronics of any kind and simply refills the toner power into the toner hopper of the printer.  Make sure all the toner was poured out of the toner bottle when refilling the toner hopper.

 

To add toner to the Oce 9400 do the following;

–          Unscrew the fastening knob at the left-hand side of the printer and open the left-hand cover.

 

–          Remove the white cap from the new toner bottle.  Be careful with handling the new toner bottle once open as toner spillage may occur.  Screw the toner bottle in, turning it clockwise and holding it in a slanted position.

 

–          Move the bottle to a vertical position.

 

–          Make sure all the toner inside the bottle empties into the printer.  You may need to lightly tap the bottle.

–          When the toner bottle is empty, return it to its original position.

–          Unscrew the toner bottle, turning it counter-clockwise.

 

IMPORTANT:  The waste toner bag must be replaced when new toner is added.  To replace the waste toner bag, do the following;

–          Pull the waste toner bag from its holder and seal the bag with the cap provided.

 

–          Slide a new waste toner bag over the holder.

–          Close the cover and tighten the access nut.

 

Print Quality Issues

 

All print quality issues are going to be printer related.  The toner bottle simply adds toner to the printer and does not permanently install into the printer.

 

For common print quality issues on the Oce printer, cleaning the glass platen can resolve some issues.  To clean the glass platen, do the following;

–          Switch the scanner off.

–          Unlock the top cover by pushing the front side of the cover down and pulling it towards you.

–          Raise the cover.

–          Gently clean the glass platen and the white pressure platen with a soft, lint-free, dry, cloth.

 

–          Lower the top cover.

–          Lock the cover by pushing the front side of the cover down and pushing it back to the rear until you hear a click.

–          Switch the scanner on.

 

If this does not resolve your print quality issues you can access additional troubleshooting with Oce directly at www.oceusa.com

 

Not Fitting

 

Verify you the correct toner for your specific printer model.

Make sure you removed the white screw on cap found on the toner bottle.

This toner bottle adds toner to the printer and does not permanently install into the printer.