CLT-K609S (Black), CLT-C609S (Cyan), CLT-M609S (Magenta), and CLT-Y609S (Yellow)

 

THESE ARE TONERS THAT HAVE THE OPC DRUMS BUILT INTO THE CARTRIDGES THEMSELVES AND EACH CARTRIDGE IS REPLACED AS ONE WHOLE UNIT.  THERE IS NO SEPARATE DRUM UNIT.

There are 4 colors in this series; Black, Cyan, Magenta, and Yellow.

These are compatible cartridges so there will be differences from the OEMs.  These differences will not affect the function.

 

There are four colors in this series of color laser toner cartridges; Black, Cyan, Magenta, and Yellow.

Not Recognizing

 

Verify you have the correct cartridges for your specific model printer.

 

There is a smart chip located on the front of the cartridge.  Check the chip for damage or debris.  A lint-free cloth can be used to gently clean the gold contacts.

 

Verify that the cartridge is fully inserted into the printer and that the correct color is being installed into the correct slot.

 

To remove and install these toner cartridges into a Samsung CLP-770ND printer do the following;

 

–          Using the handle, completely open the front cover.

 

–          Press the green release handle to release the paper transfer belt.  Holding the handle on the paper transfer belt, lift it out of the machine.

 

–          Grasp the handles on the cartridge being removed and pull to remove the cartridge from the printer.  This printer uses four different color cartridges.  Black, cyan, magenta, and yellow.  Note the location and color of the cartridge being removed.

 

–          Make sure that the color of the print cartridge matches the color slot and then grasp the handles on the print cartridge.  Insert the cartridge until it clicks into place.

–          Holding the handle on the paper transfer belt, align it with the slots on the inside of the front cover.

 

–          Lower the paper transfer belt until it is parallel with the front cover and firmly seated.

 

–          Close the front cover.  Make sure that the cover is securely closed.

 

Print Quality Issues

 

There is a piece of paper with foam that covers the front of the toner cartridge which must be removed prior to installation.

 

Slowly shake the cartridge 5 or 6 times to distribute the toner powder evenly inside the cartridge.

 

The OPC drum is located on the back of the cartridge.  Visually inspect the OPC drum for any damage or debris.  Do NOT touch the OPC drum.  A soft, clean, dry, lint-free cloth can be used to gently clean the OPC drum if needed.  Do NOT use moisture of any kind.

 

Leaking

 

This toner does not have any pull seal tabs and as a result a little toner dust on the cartridge is normal.  The protective paper cover that covers the OPC drum helps collect any loose toner dust.  However, vibrations during shipping may cause the roller to rotate a little and allow a little toner powder to leak.  This is normal.  You can clean excess toner dust off the cartridge by gently wiping the cartridge with a clean, dry, lint-free cloth or gently blowing on it.  Be careful with compressed air as this may blow too powerfully and blow toner powder out of the cartridge.  Do NOT use moisture of any kind.

 

Not Fitting

 

Verify you have the correct cartridge for your specific printer model.  Verify the correct color is being installed into the correct color slot.  Make sure the cartridge is being installed in the correct orientation.  Check inside the printer for any obstructions which may be causing the cartridge not to install correctly.  Check the cartridge itself for physical damage.