Also 109R00639, 10S0150, 113R632, 113R632, ML-4500D3, and TDR-510P

THIS IS A TONER THAT HAS THE OPC DRUM BUILT INTO THE CARTRIDGE ITSELF AND IS REPLACED AS ONE WHOLE UNIT.  THERE IS NO SEPARATE DRUM UNIT.

Not Recognizing

 

Verify you have the correct cartridges for your specific printer model.

 

This cartridge does not have a smart chip.  Instead, there is a fuse on the front of the cartridge that acts like a smart chip.  After a period of usage the fuse will break which tells the printer the cartridge needs to be replaced.  Check the fuse to make sure it hasn’t become dislodged from its holder.

 

Check to make sure the cartridge is installed correctly and fully inserted into the printer.

Print Quality Issues

 

There is a piece of paper held on by tape that protects the OPC drum which must be removed prior to installation.

 

Gently shake the toner cartridge from side to side 5-6 times to redistribute the toner.

The OPC drum is located on the bottom of the cartridge.  Visually check for scratches or debris on the drum.  Do not touch the OPC drum.  If need be, clean the OPC drum using a dry, soft, lint-free cloth.  Do not use moisture of any kind.  There is no protective drum shutter on this cartridge to protect the OPC drum so caution must be taken in handling this cartridge to prevent damage to the drum.  Be careful with setting the cartridge down on a surface because being that the OPC drum is located on the bottom of the cartridge it can easily be scratched or nicked.

 

Leaking

 

This toner does not have any pull seal tabs and as a result a little toner dust on the cartridge is normal.  The protective paper cover that covers the OPC drum has a piece of foam that covers the drum to help collect any loose toner dust.  However, vibrations during shipping may cause the roller to rotate a little and allow a little toner powder to leak.  This is normal.  You can clean excess toner dust off the cartridge by gently wiping the cartridge with a clean, dry, lint-free cloth or gently blowing on it.  Be careful with compressed air as this may blow too powerfully and blow toner powder out of the cartridge.  Do NOT use moisture of any kind.