THIS IS A TONER THAT HAS THE OPC DRUM BUILT INTO THE CARTRIDGE ITSELF AND IS REPLACED AS ONE WHOLE UNIT.  THERE IS NO SEPARATE DRUM UNIT.

Not Recognizing

 

Verify you have the correct cartridge for your specific printer model.

 

There is a smart chip located on the front of the cartridge.  Check the chip for damage or debris.  A clean, dry, lint-free cloth can be used to gently wipe the gold contacts.

 

Check to make sure the cartridge is installed correctly and fully inserted into the printer.  There are tabs on each side of the print cartridge that align with slots on each side of the print cartridge cradle inside the printer.  Slide the print cartridge into the printer until it snaps into place.

 

Print Quality Issues

 

There is a piece of foam that wraps around the cartridge and a red plastic clip on the back that must be removed prior to installation.

Hold the print cartridge by the handle and gently shake it to distribute the toner powder.

 

The OPC drum is located on the bottom of the cartridge.  Visually check for scratches or debris on the drum.  Do not touch the OPC drum.  If need be, clean the OPC drum using a dry, soft, lint-free cloth.  Do not use moisture of any kind.  There is no protective drum shutter on this cartridge to protect the OPC drum so caution must be taken in handling this cartridge to prevent damage to the drum.  Be careful with setting the cartridge down on a surface because being that the OPC drum is located on the bottom of the cartridge it can easily be scratched or nicked.

 

Leaking

 

This toner does not have any pull seal tabs and as a result a little toner dust on the cartridge is normal.  The paper that protects the OPC drum during shipping has a piece of foam that covers the OPC drum to help collect any loose toner dust.  However, vibrations during shipping may cause the OPC drum to rotate a little and allow a little toner powder to leak.  This is normal.  You can clean excess toner dust off the cartridge by gently wiping the cartridge with a clean, dry, lint-free cloth or gently blowing on it.  Be careful with compressed air as this may blow too powerfully and blow toner powder out of the cartridge.  Do NOT use moisture of any kind.